Ormco Enlight Light Cure Adhesive 1 Syringe 4 Gms + Bond 5ml (Kit) Combo

• 1 x Ormco Enlight Light Cure Adhesive 1 Syringe 4 gm
• 1 x Ormco Enlight Light Cure Ortho Solo Primer 5 ml

Direction to use 

Tooth preparation
Place the lip/cheek retractor and saliva ejector in the mouth. prophy the teeth thoroughly with pumice and water. Rinse with water while using a high-speed evacuation system.
Dry the teeth with an air syringe.
Apply the etchant solution to the bonding surfaces with applicator sponges. Gently dab the etching solution: do not rub. A continuous dabbing of fresh solution for 30 seconds is most effective. Rinse thoroughly with a forceful air-water spray and suction using a high-speed evacuator. Maintain a dry field. Do not allow the patient to rinse or permit contact of the etched
enamel with saliva or mucosal tissue.
Dry the etched enamel with clean, dry air, The etched enamel must now have a uniform, dull frosty appearance.

Bonding Procedure
Dispense a small amount of sealant on the mixing pad. apply ortho solo sealant to teeth using the brushes provided. A thin, uniform coating should extend from the gingival crest and cover all of the etched enamel. Replace the cap immediately after dispensing sealant.
Extrude a small amount of enlight adhesive paste into the base of the bracket pad. After application, clean the tip and replace the cap.
Place the bracket onto the tooth surface immediately after applying adhesive.\
Adjust the bracket to its final position and press firmly.
Remove the excess adhesive from the periphery of the base of the brackets.
With Demetron’s optilux 501, Expose the adhesive for 10 seconds for metal brackets, and 5 seconds for ceramic brackets. shining the light directly through the bracket bonds ceramic brackets. Divide the curing time and shine the light on the mesial and distal edges of the brackets to bond metal brackets.
Active archwires may be placed immediately after curring the last bracket.