Dentsply Integrity Temporary Crown And Bridge Material

Description

Dentsply Integrity Temporary Crown and Bridge Material with Fluorescence, a two-component automixed methacrylic ester formula, offers fast, strong, and aesthetically pleasing temporary restorations. With minimal shrinkage and consistent texture, it simplifies handling, reducing adjustments and saving time. Packaged in a cartridge format to minimize waste, it’s ideal for direct fabrication of veneers, inlays, onlays, crowns, and bridges in indirect restorative procedures.

Key Specification 

• Immediately before each use – Bleed cartridge prior to inserting new mix tip
• 0-5 seconds – Material dispensed into preliminary impression
• 5-45 seconds – Material inserted into the mouth
• 2-3 minutes – Removal from mouth
• 6 minutes – Remove the O2-inhibited layer and begin to trim the excess with-rotary instruments
• 7 minutes – Complete contours and polish

Composition  

• Barium glass
• Fumed Silica
• Methacrylate Monomers
• Catalyst
• Stabilizers

Packaging

• 1x 76gm Cartridge
• 20 x Small Mixing Tips

Direction To Use :

– Raise release lever vertically, pull plunger back.
– Open cartridge lock, insert cartridge notch down, close lock.
– Remove cartridge cap, discard.
– Disinfect used mixing tip for next use.
– Dispense pea-sized amount of base and catalyst, clear any blockages.
– Install mixing tip, align notches, lock in place.
– Squeeze trigger to dispense material evenly.
– Disinfect barrels and used tip after use.
– Remove cartridge by lifting lever, pull slide flush.
– Dispense small amount, inject into impression immediately.
– Leave impression for 2-3 minutes.
– Trim excess during elastic stage, avoiding distortion.